SmartyCam 3 Dual is the flagship version of SmartyCam 3 range

SMARTYCAM 3 DUAL

IF ONE IS GREAT, DUAL IS BETTER

SmartyCam 3 Dual is the flagship version of SmartyCam 3 range. It’s designed for any racer, who wants to get the most out of their performance video’s on the track.

Dual Full HD camera system, Video output, CAN connection, USB-C connection, Ethernet port. These are only few of the features of SmartyCam 3 Dual,

…the most powerful camera of our range.

FULL HD 60 FPS

VIDEO OUTPUT

GLOBAL SHUTTER CMOS SENSOR

CAN CONNECTION

INTERNAL DATALOGGER

TWO BULLET CAMS

FULL HD 60 FPS
Aim Smartycam 3 Dual Youtube
HIGHLIGHTS
configurable overlays

CONFIGURABLE OVERLAYS

The new SmartyCam 3 Dual has been designed for motorsport with a single purpose:

PROVIDING GREAT VIDEOS INCLUDING ALL INFORMATION YOU NEED

SmartyCam 3 Dual overlays all data from both GPS and AiM loggers connected to your ECU.

PROVIDING GREAT VIDEOS
SmartyCam 3 Dual overlays all data

Video Output

SmartyCam 3 Dual features a video output with SDI interface.

It allows to send the video/audio stream to a streamer at 30 or 60 fps to perform a video streaming.

RS3 STUDIO

Video Configuration and Analysis Software

SmartyCam 3 Sport uses Race Studio 3, our newly updated, powerful software designed for the configuration of videos,
gIving you the ability to get all of your vital information in one place.

SC3 CONFIGURATION

SC3 CONFIGURATION

With Race Studio 3 software you can configure your overlays in a virtually infinite variety of ways:

  • add your logo and the track map and choose your graphic objects from a list of pre-determined sets with same layout or even single objects from different sets;
  • add the second camera video in Picture in Picture mode. This way your videos will be truly “yours.

ANALYSING VIDEO WITH ANALYSIS 3

Once downloaded to your PC, your video of your session, can now be split into individual videos of each lap, so that you can simultaneously watch two of them and check where you were faster or slower.

The same operation can be performed with a SmartyCam 3 Dual video recorded on the same track so you can compare your best lap, with your friends or your personal best !

VIDEO ANALYSIS WITH ANALYSIS 3

ADDITIONAL FEATURES

Full internal datalogger

Thanks to its second CAN, SmartyCam 3 Dual receives and stores in a .mp4 file, all data coming from any CAN expansion. At the end of your test, your SD Card contains all the information you need, for a deep data analysis. The SD card is sold separately.

Designed for the extreme

An on-board camera designed for motorsport, must guarantee great resistance against the extreme working conditions typical of racing and against the most adverse weather conditions. That’s why SmartyCam 3 Dual and bullet cams, are made from tough anodized aluminium and is IP65 waterproof.

Automatic start stop

Automatic Start & Stop

Automatic start and stop

You have other things to think about while you are racing and SmartyCam 3 is aware of that. That is why it switches on/off automatically and starts/stops recording in the same way.

No "Wave Effect"<br />
with Global Shutter CMOS

No “Wave Effect” with Global Shutter CMOS

No Wave Effect

Engine rumble causes vibrations, which are a big problem for video recording. You will never experience again,  that seasick “wave effect” you get from watching videos recorded by a generic camera when the car rolls at 7,000 RPM.

SmartyCam 3 cameras have been designed for that environment and for those vibrations. The “Wave effect”,  is just a distant memory.

Automatic start stop

High quality with small size video files

Generic HD cameras are focused on the highest pixels number. The result is that their video files are far too large and take too much memory.

For this reason, SmartyCam 3 videos, have the same quality as other Full HD cameras but their files are smaller, due to the H.264 compression system parameters, that are optimized, to perfectly balance video quality and file size.

Automatic start and stop

In The Box

KIT 1:

SmartyCam 3 Dual Module + 2 Bullet cam 67° + 2 Bullet cam SMA cable length 2,000 mm
+ Standard + Ethernet Harness

SmartyCam 3 Dual KIT 1

KIT 2:

SmartyCam 3 Dual Module + 2 Bullet cam 84° + 2 Bullet cam SMA cable length 2,000 mm
+ Standard + Ethernet Harness

SmartyCam 3 Dual KIT 1 KIT 2

Technical Specs

Video format:H.264 1,920×1,080 pixels @ 60 fps
Display resolution 2.4″ 240 x 320 pixels
Lens:mLow distortion camera lens
CMOS Sensor : Global shutter
Field of view : 67°, 84° or 120°
Internal battery : Rechargeable lithium battery
Video Out: 3G-SDI
External power: 9-15 V
Supported MicroSD Card (not included): Up to 2TB
Usage temperatures: -10°C/+50°C
Auto Power ON: Yes
Auto Power OFF: Yes
Auto Start/Stop Recording: Yes
Body: Anodized Aluminum
Dimensions: Main unit 154.4 x 109.6 x 42 mm
Bullet camera 24 diam x 48.2 mm
Connectors: 1 Deutsch 22 pin + 1 SMA SDI Video out + 2 SMA bullet connection + 1 USB-C
Bullet cable length: From 500 mm to 4,000 mm (7 lengths available)
Weight: Main unit 800 g | Bullet 45 g
Waterproof: IP65

Smartycam 3 Dual tech 1

Smartycam 3 Dual tech 2

Technologies

Aim Shop

Services

Support